The consequent application of different physical laws in the separator type QUICKSEP 300 as well as the optimal combination of the suction float and the pump are responsible for the very high separation efficiency of these units.
The unwanted and free oils are thoroughly separated from all contaminated fluids such as metal cutting emulsions, wash baths, hardening baths etc. The clean medium from which the unwanted oils have been separated flows back to the treatment tank by gravity. The separation performance lies at over 98% when demulsifying fluids are used.
Except for the pump and the motor there are no moving parts within the oil separator Quicksep 300. Due to this fact maintenance costs are reduced to a minimum of rinsing the unit once or twice per year. The standard execution of the oil separator QUICKSEP 300 is delivered completely with oil tank with overflow protection, hydraulic dry run protection for the pump (eccentric “MONO”-type pump only), as well as feed and return tubes.
For the aspiration in emulsion tanks a variety of suction floats are available to suit specific requirements. A pre filter, air sparger under the filter media bed, air operated membrane pump etc. are available as options. All units are built for ambient temperature. Special reinforced units for temperatures over 40°C up to 80°C are available on special request.
700 mm, 960 mm
(without pre filter)
(with pre filter)
|86 litres |
approx. 70 kg
|Pumping capacity nominal: |
|approx. 600 l/h || |
|Pumping capacity effective: |
|approx. 300 l/h |
3x400 Volt, 0,35 kW
Air operated membrane pump or peristaltic pump